BF flotation cell has two types: type I and type II. Type I is improved as suction cell referring to model SF; type II is improved as direct flow cell referring to model JJF.
Each feeding inlet of Xinhai cyclone unit is installed knife gate valve independently developed by Xinhai. This valve with small dimension reduces the diameter of cyclone unit.
The supports at both ends of cone crusher main shaft, scientific design of crushing chamber, double insurance control of hydraulic and lubricating system.
Wet type overflow ball mill is lined with Xinhai wear-resistant rubber sheet with excellent wear resistance, long service life and convenient maintenance
Wet type grid ball mill is lined with Xinhai wear-resistant rubber sheet with excellent wear resistance design, long service life and convenient maintenance.
Ring groove rivets connection, plate type screen box, advanced structure, strong and durable Vibration exciter with eccentric shaft and eccentric block, high screening efficiency, large capacity
Xinhai improves the traditional specification of crushing chamber by adopting high speed swing jaw and cambered jaw plate.
High-speed hammer impacts materials to crush materials. There are two ways of crushing (Wet and dry)
The cone slide valve is adopted; the failure rate is reduced by 80%; low energy consumption;the separation of different material, improvement of the processing capacity by more than 35%.
Cylindrical energy saving grid ball mill is lined grooved ring plate which increases the contact surface of ball and ore and strengthens the grinding.
20-30%. Rolling bearings replace slipping bearings to reduce friction; easy to start; energy saving 20-30%
Both sides of the impeller with back rake blades ensures double circulating of slurry inside the flotation tank. Forward type tank, small dead end, fast foam movement
I have a 30%Ni-70%Cu alloy. how can I seperate copper and nickel Then wait until the matte cools down, during which time, particles of copper sulfide, nickel sulfide, You may dissolve the alloy by some methods like acid leaching and obtain a If understood well, problem is separating Cu and Ni from alloy, not ore
Smelting of nickel sulfide ores yields a matte in which nickel and copper make and the sulfides of copper and nickel are separated before being reduced to the
May 25, 2010 in leach solutions; economic methods of solution purification such as solvent leaching and eventual Cyanex 272 separation of nickel and cobalt. Historically of course almost all nickel sulphide ores have been treated in this way; common impurities found in leach liquors, such as copper, zinc, iron II,
This book describes and explains the methods by which three related ores and . The balance is smelted to sulphide matte for refining to nickel metal and other nickel .. Separation of nickel concentrate and copper concentrate from the bulk
The main source of the worlds nickel is from copper-nickel sulphide ores with those Generalized Flowsheet of the INCO Matte Separation Process is as follows: INCO nickel using the MCLE Matte Chlorine Leach Electrowinning method.
PGMs are generally associated with nickel-copper sulphides in magmatic rocks, and there are many Outotec Ausmelt Process for primary nickel concentrates smelting and matte converting. All these hydrometallurgical methods to recover copper, nickel, cobalt, and PGMs. Process gas During matte separation by.
several stages: I . Ore concentration by physical techniques such as flotation. 2 . Ivrometallurgical concentration producing copper-nickel sulphide matte, and
matte was obtained from high grade Ni-Cu matte by magnetic separation, which mainly contained Ni-Cu alloy and a small quantity conventionally treated by pyrometallurgical method, nickel or nickel sulphide powder after the liquid−solid.
Process for recovering nickel and nickel-copper from molten smelter-type slags or 3,754,891 entitled Method of Producing Iron-Poor Nickel Sulphide Matte a reduction scheme but merely employs physical separation of a matte from a slag.
Nickel sulphide ore subjected to this investigation was taken from the of gravity-separation and flotation methods was applied for the concentration of The slow cooling of Bessemer converter matte forms discrete phases of Cu2S, Ni3S2,
Cobalt extraction refers to the techniques used to extract cobalt from its ores and other compound ores. Several methods exist for the separation of cobalt from copper and nickel. Nickel sulfide concentrates can be treated by either roasting or flash smelting to produce matte from which nickel and cobalt can be recovered
Copper extraction refers to the methods used to obtaining copper from its ores. The conversion If the ore is primarily sulfide copper minerals such as chalcopyrite, the ore is crushed A key objective in the metallurgical treatment of any ore is the separation of ore minerals .. 98% pure, containing antimony and nickel.
of the nickel sulphide-copper sulphide matte. It is not possible . Furnace ISF was developed, expensive froth flotation separation techniques were required to
May 2, 2011 Copper-nickel-sulphide ores mined in the Rustenburg district of South Africa functions of the electric furnace are to recover most of the matte content in the the furnace bath and to provide adequate time for the optimum separation of matte and .. "Techniques of process analysis in extractive metallurgy"
Flash smelting is a comparatively new method of smelting copper and nickel sulfide concentrates. It takes . the rich matte and the slag were easily separated.
Jan 12, 2017 In the treatment of copper-nickel sulfide ores, separation of copper from the This article describes techniques adopted by Inco on the basis
Nickel sulfide processing can be separated into the three processing stages: . Various processes exist to convert the nickel matte into marketable products. Leaching dissolves the valuable metals - nickel, copper and cobalt - but leaves.
sulphides, the process is called matte smelting and when metal is separated as liquid metal it is called reduction which is an intermediate product in the extraction of copper from sulphide ores. In production Next is copper- nickel matte.
industries concerned on best available techniques, associated monitoring, and de- Primary non-ferrous metal production in Finland concerns only copper, nick- recover nickel from sulphide concentrates and it is the main process described in .. 4.9 Dust separation .42.
Flowsheets of nickel-copper extraction at Copper Cliff—1995. . heat boilers, with the melting, the furnace reactions and the separation of matte secondary factors. explored direct nickel sulfide conversion to oxygen crude nickel in a three tonne Since 1993, Inco has commercialized several innovative techniques for
a nickel or nickel-copper matte, which is further processed to nickel or nickel oxide by hydrometallurgical, pyrometallurgical, or vapometallurgical methods. Figure 1-1. . a much lower content of nickel and copper sulphides, and contains much more chromite than . a low viscosity to allow clean slag-matte separation.
Analysis of Duluth gabbro copper-nickel bulk sulfide concentrate •••••••••. Operating data for . Matte smelting emits S02 and recovers the following, in as a possible extraction method. LEACHING .. extraction. LIQUID-SOLID SEPARATION.
In this e-source, well look at the ways of extracting copper from the ground. in the ore as that also contains unwanted silicates and other minerals, called gangue, that will have to be separated. Open pit: 90% of ore is mined by this method. The liquid matte is oxidised with air to form blister copper in a converter.
still contained 0.25 g dm-3 of iron which was quantitatively separated by a lime and nickel but copper, manganese and zinc were coprecipitated to some In recent years the solvent extraction technique has been Nickel is usually extracted from sulphide ores using is extracted during processing of nickel matte by.
supply from lateritic deposits as processing techniques occurs as nickel, cobalt and copper sulphides, possibly with evaporites led to the separation of an immiscible sulphide . and cobalt are recovered as a sulphide matte, containing.
The usual method of nickel extraction from sulfide ores is through the production of nickel matte after enriching the nickel This is com- monly carried out by magnetic separation, flotation, . contain very low grades of nickel 0.6% and copper.
Generally, this conventional method needs complex and energy-intensive Subsequently, the nickel-copper matte is smelted and converted into dominated by nickel and copper sulfides with a small amount of iron sulfide. After that, the converter matte is separated into nickel concentrate and copper concentrate by
Aug 22, 1978 3293027, Method of leaching high grade nickel matte, 1966-12-20 . for separating platinum group metals from copper-iron-nickel sulfide ores
Sep 6, 2017 They also stated that nickel sulfide ores mined for nickel need a In pyrometallurgy, metals are separated from the contents of the matte by using heat – to . Another method of copper and nickel powder production, reported
See nickel matte The valuable mineral has to be separated from the surrounding mining methods. Nickel and Copper sulphide ores need further crushing.
The magmatic copper-nickel sulphide deposits at Sudbury are part of the Paleoproterozoic The primary mining methods used at Coleman Mine are Post Pillar sulphides by magnetic separation and flotation in the Matte Separation Plant.
Jun 9, 2012 type extractant and for the separation of cobalt and nickel with alkyl technique for the extraction of copper, nickel, zinc and cadmium using
earliest copper-nickel alloy objects which are known to have . In the sulfide ores, nickel occurs chiefly as the mineral .. erals, and beneficiation methods such as flota- tion and centrate from the matte separation process is roasted in
Extraction of Cobalt From Copper–COBALT Ores. 1.3. Extraction of . Summary. Chapter 24. Leaching of Nickel Sulfide Mattes and Precipitates. 24.1. Separation Techniques Used in the Refining of the Platinum-Group Metals. 37.4. Refining
The refining process begins with nickel matte or crude nickel products delivery to the refining stage The SOx allocation rule applies to the leachingseparation stage. Cu, PGMs matte or sulfide anodes to produce CoO and Ni cathodes.
and oxidized iron as a slag, leaving a ferrous nickel copper matte. ln contains copper, the matte can be separated into nickel subsulfide, copper sulfide traction methods using tributylphosphate and aliphatic amines diluted in petro-.
The aim was to achieve maximum copper and nickel recovery by investigating the Matte is a mixture of metal sulphides and precious metals produced from the smelting of sulphide ores. There are different types of leaching techniques and each type has requirements in .. Separation and Purification Technology, vol.
Oct 24, 2017 sulphide concentrate with 20–30% Cu and the current average is ~25% Cu, which is and matte separation and tapping methods are used in different furnaces. . Arsenic, nickel, and cobalt dissolve and remain in the.
Recovery of copper and cobalt from smelter slag using reductive-sulfurizing smelting method was performed in this study. The effects of reductive results showed that the main phases of copper-cobalt matte were iron sulfide FeS, geerite Cu8S5, iron cobalt sulfide together with nickel and copper from a variety of.
May 14, 2017 The largest domestic nickel sulfide deposit referred to as the Duluth To aid in the separation of nickel and copper, the leaching step is usually With this method, a portion of the nickel is preferentially extracted from the
1993-2018 Xinhai Machine . All rights reserved | Design by Xinhai